Table des Matières
Publicité
Installation Instructions - Intergrated Application
Tools You Will
Need
FOR YOUR SAFETY:
While performing
installations described in
this section, gloves, safety
glasses or goggles should
be worn.
Preparing the
Enclosure
Electrical Requirements:
The appliance must be
connected to an individual
properly grounded electrical
outlet, protected by a 15 or
20 ampere circuit breaker or
time delay fuse.
Safety Glasses
Drill & Hole Saw set
• It is recommended that you de
not install the beverage center
into a corner (i.e. directly beside
a wall). This is to allow the
door(s) to have a greater then
90° opening swing. A limited
door swing will prevent the
shelves from sliding out as
intended, and may lead to dam-
aging the door gasket(s).
• The rough cabinet opening
must be on a level floor area
and at least 25" deep by 24"
wide. The opening should also
have a height of at least 35".
1-1/2" dia. hole
*if electical outlet
is in adjacent
cabinetry
35"
From
Underside of
Countertop to
Floor
Electrical Access
Fig C
8
Gloves
Flashlight
Measuring
Tape
• The electrical oulet may be
positioned from within either
side of the adjacent cabinetry, or
the rear of the shaded area (as
shown in Fig C.).
• If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1-1/2" diameter hole to admit
the power cord. If the cabinet
wall is metal, the hole edge
must be covered with a bushing
or grommet.
24"
Min.
2"
Cabinets
Square
and
Plumb
6"
24"
Level
Carpenters
Square
Publicité
Chapitres
Table des Matières
