Operating By Remote Control - Napoleon Fireplaces BEF33H Instructions D'installation Et D'opération

14
4.2

OPERATING BY REMOTE CONTROL

EN
TO AVOID DANGER OF SUFFOCATION KEEP THE PACKAGING BAG AWAY FROM BABIES AND
CHILDREN. DO NOT USE IN CRIBS, BED, CARRIAGES OR PLAY PENS. THIS BAG IS NOT A TOY.
NOTE: When operating the remote control, it must be directed towards the front center of the appliance.
A. Make certain the appliance's main power switch is at the ON
position on the control board. The appliance will default to the
brightest fl ame setting when main power is initially switched to ON
position.
B. The power button can be used to power up or down the appliance
(the main power switch on the appliance must be in the ON position
for the remote to operate). Pressing this button
power to the appliance. Pressing this button
the appliance. The ember and log will fade out after 4 seconds.
C. To adjust the fl ame brightness, press the fl ame button
are three brightness levels to cycle through and then an off setting
(F1, F2, F3 and then F0).F3 is the brightest level.
D. To begin the thermostat function press the thermostat button
there are 6 temperature settings (61°F, 64°F, 70°F, 75°F, 81°F and
off). Press the thermostat button to cycle through the settings.
Once you have selected the desired temperature the heater will
automatically function until that temperature is reached. The default
setting will display Fahrenheit. When the room temperature is a
degree lower than the temperature setting, the heater will turn on.
E. To activate the heater, press the heater button
heater will turn on. Press the heater button again to turn off the
heater, the blower will remain on for 8 seconds.
F. To activate the timer, press the timer button
illuminate and the time will appear on the LED display. To choose
the desired time, continue to press the timer button, there are 6
settings (1hour, 2h, 3h, 4h, 5h and off), each setting represents hours of operation. The fi replace will
turn off at the setting time.
G. To activate the decoration light, press the light button
and then an off setting (d1, d2, d3 and then d0). d1 white colour, d2 colour cycles from white to orange
to blue to orange & blue to blue & orange to white & blue. It will take 8.5 seconds to switch from one
colour to the next when in d2 setting, d3 will lock to a desired colour.
H. To turn off the appliance, press the power button once on the remote, or switch the main power to off/
on the control panel on the unit.
NOTE: This hand held remote control must remain within 6 meters or 19 feet of the appliance to be
effective.
W415-1299 / B /
06.16.14
WARNING
!
KNOT BEFORE THROWING AWAY.
activates the
again will turn off
. The blower and
, the icon will
. There
,
.There are three settings to cycle through