Operation - Warn Industries 81580 Instructions D'installation

V. Operation
Attaching the plow to the vehicle
1. Stage the plow assembly on level solid ground.
See Plow operator guide "Installing the Plow" for
more information on installing plow mount flange
(A4). See Figure 9.
2. SLOWLY drive the vehicle up to the plow
assembly with the vehicle as square to the plow
as possible.
3. Turn off the vehicle and set the parking brake.
Lift the plow mount flange end of the push tube
assembly up to the plow mount on the vehicle.
Insert the plow mount flange into the plow mount
receiver. See Figure 10.
4. Double check that the plow is fully engaged with
the alignment pucks on the plow mount flange.
The alignment pucks should be fully seated into
the plow mount cradle feature.
5. With both alignment pucks seated into the plow
mount the retaining pins can be inserted. Once
inserted the retaining clips on the pins can be
clipped onto locking tab on plow mount, refer to
Figure 11. See Plow operator guide "Installing
the Plow" for more information.
6. With both retaining pins secure, pull out the line
from the winch.
7. Pull the retaining pin on the plow assembly that
is securing the pulley assembly. With the pulley
assembly loose, place the pulley assembly over
the winch line and reinstall the pulley assembly
onto the push tube assembly securing the pulley
assembly with the retaining pin. See "Double
Line Rigging" in the Plow Lift section of the Plow
Operators Guide.
WARN® INDUSTRIES
Figure 9 Install Plow Mount Flange
Retaining Pin
PAGE 7
A4
Figure 10
Retaining
Pin
Figure 11
82702A0