Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
IV. Installation
1.
Remove plastic guards on inside of fender on
both sides of vehicle using a T25 Torx bit, as
shown in Figure 1.
2.
Remove (3) capscrews on bottom side of bumper
using a 14mm socket, as shown in Figure 2.
Rotate bumper forward for access to back side.
3.
Attach right and left side mounting brackets to
side of bumper using (2) M8 x 1.25 x 30mm
capscrews, flat washers and locknuts, as shown
in Figure 3, using a 13mm socket/wrench. Do
not tighten at this time.
NOTE: If winch is installed in vehicles
bumper, remove rear (2) capscrews on each
side and replace with longer capscrews
specified above.
WARN® INDUSTRIES
PAGE 4
T25 Torx Screws
Figure 1
Figure 2
Figure 3
82702A0
Publicité
Chapitres
Table des Matières
