Warn Industries 81580 Instructions D'installation page 6

Installation continued
7. Earlier model year Rangers will not have slots in
front of bumper. If this is the case, remove
bumper from vehicle and place the rear support
bracket on the back side of bumper in orientation
shown in Figure 7.. Mark the center of the slots,
remove support bracket and drill 7/16" holes in
marked locations. Left and right brackets can
then be secured to bumper as described in Step
6.
8. Tighten all hardware to specifications on page 2.
For best results, tighten front bumper hardware
last. Rotate bumper back into place and secure
with original hardware.
Plastic guards on inside of fender will need to be
trimmed as required or left off vehicle.
9. Completed installation is shown in Figure 8.
WARN® INDUSTRIES PAGE 6
Figure 7
Figure 8
82702A0