Getting Started - Ribimex Ribiland PRSWIM370/1 Manuel D'instructions Et D'utilisation

IV. GETTING STARTED
Before any intervention on product, ensure that product is disconnected form its
power source.
4.1- Unpacking
- Remove product from its packaging.
- Check that product and accessories are not damage
4.2- Scope of supply
- Pool circulating pump
- Installation and Operating Instructions.
4.3- Description of the pool circulating pump (Fig. 1)
The pump housing is constructed of fiberglass reinforced plastics for use near swimming pools.
The pump is of the canned- rotor type, self-priming and with single motor.
The inlet port is equipped with a lint strainer in order to prevent coarse impurities entering and
jamming the pump.
Standard thermal overload contacts (WKS) prevent damage to the pump due to excess current draw.
The WSK is, however, only effective in conjunction with an appropriate switch-box.
The pump draws water from the pool, e.g. via a skimmer and pumps it back to the pool via the filter
The suction pump and the filter must be installed closed to each other.
Resistance to chemicals are limited by the following limits:
• Max. water temperature: +35°C
• pH-value: min. 6 ; max. 7.8
• Free chlorine: 0.2 up to max. 2.0 mg/l (or ppm). Short term limit e.g. for reconditioning of pool
water max. 20 ppm.
• Free chlorides: max. 250 mg/l
• The pump is not suitable to handle sea or salted water.
• The pump must not be used to handle water conditioned by Sodium Hypochlorit (by electrolysis)
• Pump must not run dry.
4.4- Pump set-up
Remarks:
Only competent personnel should perform the assembly.
The user must contract a qualified and skilled person having read the contents of the manual.
Works on the filter pump should take place with the pump disconnected from its power source.
Take into account the data written on the nameplate.
The installation must be carried out in compliance with local and/or national laws by qualified
personnel so as to avoid danger.