Grizzly ERM 1637-3 Stow Traduction De La Notice D'utilisation Originale page 22

GB
as deflection and/or grass coll-
ection devices.
• Do not overload the equip-
ment. Work only within the spe-
cified power range and do not
change the regulator settings
on the motor. Do not use low-
powered machines for heavy
work. Do not use your equip-
ment for purposes other than
those for which it is designed.
• Do not use the equipment near
inflammable liquids or gases.
Non-observance will result in a
risk of fire or explosion.
• Do not lift or carry the equip-
ment when the motor is run-
ning.
• Turn off the appliance, unplug
it from the mains and check
that all moving parts are at
rest:
- Whenever you leave the ma-
chine,
- Before cleaning the
ejection hole or removing
blockages,
- When the equipment is out of
use,
- Before checking, cleaning or
working on the equipment,
- If the power cable is dama-
ged or frayed,
- If the equipment has hit a
foreign object or if strange
vibrations occur during work.
In this case, check the equip-
ment for damage and have it
repaired if applicable.
• Do not place feet or hands
near or under rotating parts.
Do not stand in front of the
grass ejection hole during sick-
le mowing.
22
Maintenance and Storage:
When servicing the blades,
remember that they can
move even if the power
source is off.
• Ensure that all nuts, bolts and
screws are tightened firmly and
the equipment is in safe wor-
king condition.
• Check the mower for any da-
mages.
• Repair damaged parts as ap-
propriate.
• Do not attempt to repair the
equipment yourself unless you
have been trained to do so.
Any work not specified in these
instructions is to be carried out
only by customer service cen-
tres that we have authorised.
• Keep the equipment in a dry
location and out of reach of
children.
• Handle the equipment with
care. Keep tools sharp and
clean, in order to facilitate bet-
ter and safer work. Follow the
maintenance instructions.
• Wear protective gloves when
changing the cutting device.
• Regularly check the grass
collection device for wear and
strains. For safety reasons, re-
place worn or damaged parts.
When adjusting the blades,
take particular care to avoid
fingers being trapped between
the rotating blades and fixed
parts of the machine.
• Check that only replacement
tools authorised by the manuf-
acturer are used.