Allmand Night-Lite E-Serie Mode D'emploi page 14

Portable Light Tower
Operation
Adjusting The Lights
WARNING
Burn Hazard
• Adjusting the lights while illuminated
could result in death or serious inju-
ry. Always adjust the lights with the
unit shut down.
Adjusting The Light Fixtures
NOTE: The light fixtures must be adjust-
ed before raising the light tower.
1. Shut down the unit. See Operating
The Tower Lights. Wait 10 minutes
for the lights to cool.
2. Grasp and swivel the fixture yoke (A,
Figure 9) to adjust each fixture side to
side.
3. Loosen the light fixture locking knob
(B, Figure 9) to adjust each fixture
up or down. Tighten the locking knob
after adjusting.
4. When lighting operations are com-
plete, adjust the light fixtures to the
transport position. See Transport
Position.
B
Figure 9
14
Rotating The Light Tower Mast
Rotating the light tower mast will cause
the light fixtures to swing, and could
result in minor to moderate injury. Be
careful to rotate the tower slowly, and
be aware of the light fixtures while
rotating the tower.
1. Shut down the lights. See Operating
2. Loosen the light tower mast lock knob
3. Use the handles (B, Figure 10) to
4. Tighten the light tower mast lock
Failure to tighten the light tower mast
lock knob could cause the light fixtures
to swing inadvertently, especially in
windy conditions or during transport,
and could result in death or serious
injury. Always tighten the light tower
mast locking knob securely after rotat-
ing the light tower mast.
5. When lighting operations are com-
A
CAUTION
The Tower Lights. Wait 10 minutes
for the lights to cool.
(A, Figure 10).
rotate the light tower mast in the
desired direction.
knob.
WARNING
plete, rotate the light tower mast to
the transport position: Align the light
tower mast tab (C, Figure 10) with the
front center of the light tower base.
Tighten the light tower mast lock
knob securely. See also Transport
Position.
www.allmand.com