Refrigerator Door(S) And Drawer - Jennair JFC2089BEM Mode D'emploi

Connect to Refrigerator
1. Create a service loop (minimum diameter of 2 ft [61 cm])
with the copper tubing. Avoid kinks when coiling the copper
tubing.
2. Remove the plastic cap from water valve inlet port. Place a
compression nut and sleeve on the copper tubing.
3. Insert the end of the copper tubing into the water valve inlet
port. Shape tubing slightly so that the tubing feeds straight
into the port to avoid kinks.
4. Slide the compression nut over the sleeve and screw into the
water valve inlet port.
A. Plastic water tubing
B. Sleeve
5. Using an adjustable wrench, hold the nut on the plastic water
line to keep it from moving. Then, with a second wrench turn
the compression nut on the copper tubing counterclockwise
to completely tighten. Do not overtighten.
A
B
C
D
A. "P" clamp C. Compression nut
B. Plastic water line D. Copper tubing
6. Check connection by pulling on copper tubing. Attach copper
tubing to refrigerator cabinet with a "P" clamp. Turn on water
supply to refrigerator and check for leaks. Correct any leaks.
6
A
B
C
D
C. Compression nut
D. Copper tubing
Complete the Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
NOTE: Allow 24 hours to produce the first batch of ice.
Discard the first three batches of ice produced. Allow 3 days to
completely fill the ice container.

Refrigerator Door(s) and Drawer

All graphics referenced in the following instructions are included
later in this section after "Final Steps."
TOOLS NEEDED: 5/16", 3/8", 1/4" hex-head socket wrench,
a 3/32" hex key, #2 Phillips screwdriver, and a flat-blade
screwdriver.
Remove and Replace Handles
1. Using a 3/32" hex key, loosen the two setscrews located on
the side of each handle. See graphics 2 and 4.
2. Pull the handle straight out from the door. Make sure you
keep the screws for reattaching handles.
3. To replace the handle, reverse the directions.