Location Requirements; Electrical Requirements; Water Supply Requirements - Jennair JFC2089BEM Mode D'emploi

Location Requirements

WARNING
Explosion Hazard
Keep ammable materials and vapours, such as petrol,
away from refrigerator.
Failure to do so can result in death, explosion, or re.
IMPORTANT: This appliance is intended to be used in a
household and similar applications such as:
Staff kitchen areas in shops, offices and other working
■
environments.
Farm houses and by clients in hotels, motels and other
■
residential type environments.
Bed and breakfast type environments.
■
Catering and similar non-retail applications.
■
To ensure proper ventilation for your refrigerator, allow for
1/2" (1.25 cm) of space on each side and at the top. Allow for
1" (2.54 cm) of space behind the refrigerator. If your refrigerator
has an ice maker, allow extra space at the back for the water line
connections. When installing your refrigerator next to a fixed wall,
leave 2¹⁄ " (6.3 cm) minimum on the hinge side (some models
2
require more) to allow for the door to swing open.
NOTE: This refrigerator is intended for use in a location where
the temperature ranges from a minimum of 55°F (13°C) to a
maximum of 110°F (43°C). The preferred room temperature range
for optimum performance, which reduces electricity usage and
provides superior cooling, is between 60°F (15°C) and 90°F
(32°C). It is recommended that you do not install the refrigerator
near a heat source, such as an oven or radiator.
1/2" (1.25 cm)
4
2 ¹⁄₂ " (6.3 cm)

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its final location, it
is important to make sure you have the proper electrical
connection.
Recommended Grounding Method
A 115 V, 60 Hz., AC only 15 A or 20 A fused, grounded electrical
supply is required. It is recommended that a separate circuit
serving only your refrigerator be provided. Use an outlet that
cannot be turned off by a switch. Do not use an extension cord.
If the supply cord is damaged it must be replaced by the
manufacturer or its service agent or similarly qualified person. Do
not use a cord that shows cracks or abrasion damage along its
length or at either the plug or connector end.
NOTE: Before performing any type of installation, cleaning,
or removing a light bulb, turn Cooling OFF. Press both the
Refrigerator Minus (-) button and the Freezer Minus (-) button until
the word OFF appears in each display. Disconnect the refrigerator
from the electrical source. When you are finished, reconnect the
refrigerator to the electrical source and reset the temperature
controls to the desired setting. See "Using the Controls."

Water Supply Requirements

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
TOOLS NEEDED:
Flat-blade screwdriver
■
7/16" and 1/2" Open-end or
■
two adjustable wrenches
IMPORTANT:
Connect to a potable water supply only.
■
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
All installations must meet local plumbing code requirements.
■
1/4" Nut driver
■
1/4" Drill bit
■
Cordless drill
■