Level And Align Refrigerator - Jennair JB36NXFXLE Mode D'emploi

After the refrigerator is leveled and aligned, remove
the installation block from the door hinge and use
it to check the spacing between the panels and
adjacent cabinets.
NOTE : The installation block is designed to provide
accurate spacing for 3/4" (1.9 cm), 3/8" (9.53 mm) and 1/8"
(3.18 mm).
3/4"
(1.9 cm)
1.
Place top of cardboard carton or plywood under
refrigerator. Remove dolly.
2.
Move the refrigerator straight back and evenly into
the opening. Be sure that the water tubing is not
kinked and the power supply cord is on top of the
refrigerator.
NOTE : If the power supply cord is behind the
refrigerator, it will not install properly.
3.
Make sure the installation block is flush with the
adjacent cabinets.
NOTE : To achieve a flush installation, it is critical to
verify a 3/4" (1.9 cm) depth from the front face of the
adjacent cabinetry to the refrigerator.
A
B
3/4" (1.9 cm)
C
A. Adjacent cabinet or wall
B. Installation block
C. Face of refrigerator

LEVEL AND ALIGN REFRIGERATOR

1/8"
(3.18 mm)
3/8"
(9.53 mm)
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT : All four leveling legs must contact the floor
to support and stabilize the full weight of refrigerator.
Rollers are for moving the refrigerator, not for permanent
support.
After moving the refrigerator to its final location:
1.
Use a 5/16" socket driver to turn the leveling bolts
clockwise
The rollers should be off the floor.
A B
2.
Adjust the leveling legs to level and align the
refrigerator from
the refrigerator is level and aligned with the cabinets.
3.
Continue adjusting the leveling legs until the top of
the
the solid soffit, or the bottom of the anti-tip boards, if
anti-tip boards were used. Do not crush the
compressor cover.
WARNING
Tip Over Hazard
to extend the legs to the floor as shown.
A. Rear leveling bolt
B. Front leveling bolt
left to right and front to back so that
refrigerator is making contact with the bottom of
A
2" (5 cm)
C
A. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards
B. Attach to studs with six #8 x 3" (7.6 cm) screws
C. Compressor cover
D. Distance from bottom of anti-tip board to floor
A
B
B
84"
(213.4 cm)
D
17