Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
A
B
3/4" (1.9 cm)
C
A. Adjacent cabinet or wall
B. Installation block
C. Face of refrigerator
Level and Align Refrigerator
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT: All four leveling legs must contact the floor to
support and stabilize the full weight of refrigerator. Rollers are for
moving the refrigerator, not for permanent support.
After moving the refrigerator to its final location:
1. Use a 5/16" socket driver to turn the leveling bolts clockwise
to extend the legs to the floor as shown. The rollers should be
off the floor.
A
B
A. Rear leveling bolt
B. Front leveling bolt
2. Adjust the leveling legs to level and align the refrigerator from
left to right and front to back so that the refrigerator is level
and aligned with the cabinets.
3. Continue adjusting the leveling legs until the top of the
refrigerator is making contact with the bottom of the solid
soffit, or the bottom of the anti-tip boards, if anti-tip boards
were used. Do not crush the compressor cover.
22
IMPORTANT: Adjust in small increments to keep from damaging
the cabinet trim and causing problems with the door alignment or
top grille fit. To avoid damage to the cabinet or leveling legs, do
not apply more than 50 inch-pounds (5.65 Nm) of torque to the
leveling bolts. The leveling legs can be extended to a maximum of
1¹⁄
" (3.18 cm) below the rollers.
4
2" (5 cm)
C
A. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards
B. Attach to studs with six #8 x 3" (7.6 cm) screws
C. Compressor cover
D. Distance from bottom of anti-tip boards to floor
4. After leveling the refrigerator, use a straight edge or 4-ft level
going across the front of the refrigerator installation to the
cabinets to check that the refrigerator is still flush.
Install Refrigerator and Panels
IMPORTANT: JennAir is not responsible for the removal or
addition of molding or wood overlay panels that would not allow
access to the refrigerator for service.
Install Top Grille Filler (standard installation only)
IMPORTANT: The grille panel height allows the necessary airflow
for refrigerator performance. The top grille filler hides the upper
compartment cover behind the top grille. If you choose to modify
the recommended grille panel dimensions, performance will be
compromised.
Custom Wood Panel Models
1. In the custom made (1" x width of grille panel) wood filler
piece, drill a hole 11/16" from each edge.
NOTE: Make sure the hole is centered in the 1" thickness of
the wood piece.
2. Using slotted hex-head screws (provided with refrigerator),
fasten an "L" bracket to each end of the wood filler piece.
3. Using hex-head blunt screws (provided with refrigerator),
A
attach the "L" brackets to the top grille mounting plates.
B
4. Adjust the "L" brackets, so that the wood filler piece is flush
with the bottom of the soffit. Completely tighten the screws.
A
B
84"
(213.4 cm)
D
Publicité
Table des Matières
