Controls & Connections: Defiance V10/V12 - Paradigm DEFIANCE Série Manuel Du Propriétaire

CONTROLS & CONNECTIONS:
Defiance V10/V12 (cont'd)
3. ARC Input
The ARC USB connection is used to connect the subwoofer to PC/
Laptop when running ARC (Anthem Room Correction — sold separately).
NOTE: Not required when running ARC via Bluetooth.
4. Status Indicator
The subwoofers is equipped with a multi-colored LED, (located on the
rear) which indicates the current status of the subwoofer
• No illumination — Subwoofer is not on.
• White — Subwoofer is on
• Red — Subwoofer is in 'Standby mode'
• Flashing — Subwoofer has detected an error code.
5. Power Mode
The Power Mode switch allows you to control how the subwoofer turns
On & Off.
• Auto — When set to "Auto", the subwoofer will turn on when an
audio signal is detected.
NOTE: After several minutes of inactivity the subwoofer will enter
Standby Mode.
• On — When set to "On", the subwoofer will always be on.
NOTE: If the subwoofer enters Standby Mode during quiet or low
level audio playback, this is likely due to a low audio output signal
from the audio system. Increasing the system volume should resume
normal subwoofer playback. Increasing the subwoofer output level
on the Preamp/Receiver and decreasing the level on the subwoofer
will solve this issue in the future for similar listening levels.
6. Speaker Level Inputs (Left/Right)
The Speaker Level Inputs allows standard speaker cable be used for
the subwoofer connection. To use these connections the speaker cable
should be terminated using banana style plugs.
19