Setting Subwoofer Controls; (Crossover Set By Preamp/Receiver) - Paradigm DEFIANCE Série Manuel Du Propriétaire

SETTING SUBWOOFER CONTROLS

(Crossover Set By Preamp/Receiver)

1. Turn the Level control completely counterclockwise to its minimum.
2. Turn the Low Pass Filter control to its highest frequency (i.e. Bypass).
3. Switch the Phase control to 0° (if not already set to 0°).
4. Listen to a bass music or video selection while seated in your primary
listening area and have an assistant turn up the Level control until the
subwoofer can be clearly heard.
5. With the help of an assistant, switch the Phase to 180°. If bass
response is now more pronounced, your subwoofer and front
speakers are now in phase. Do not change phase alignment again
unless you move the subwoofer or front speakers to a different
location in your room, or move or remove any large items of furniture
or room furnishings (i.e. carpet, draperies, etc.) TIP: Defiance
V10/V12: Using the app, slowly rotate the Phase control until you
hear the most bass.
6. Turn the Level control completely counterclockwise to its minimum.
7. Slowly rotate the Level control until you match the subwoofer's
volume with the Volume of your front speakers. Bass should be
clearly audible, but not intrusive.
NOTE: If you happen to have an SPL meter, set the meter to 80, SLOW
and C weighted. Then enable the subwoofer test tones on your Preamp/
Receiver. With this set repeat Step 7 until the meter reads 75dB.
25