Paradigm DEFIANCE Série Manuel Du Propriétaire page 20

'PAIRING' THE DEFIANCE WT
WIRELESS SYSTEM (Sold Separately):
Defiance V10/V12 ONLY (cont'd)
The Defiance WT Wireless System is shipped already paired. To re-sync
the wireless system:
1. Verify the subwoofer is powered on and that the subwoofer's status
light is red or white.
2. If the Wireless Transmitter's power cord is plugged in, unplug it for
10 seconds.
3. Plug in the Wireless Transmitter's power cord.
4. Plug the Wireless Receiver into the "Wireless Module Connection"
input on the back of the subwoofer (see diagram below).
5. Wait until the status lights begin flashing on both the Wireless
Receiver and Wireless Transmitter.
6. Push the Wireless Receiver's sync button for 5 seconds.
7. Push and hold the Wireless Transmitter's sync button until the
Wireless Receiver's status light turns solid.
17
WARNING! To prevent signal dropouts or
interference, keep the Wireless Transmitter well out
of range of a microwave oven, mobile telephone or
Bluetooth device operating on the same frequency.
IMPORTANT! The Wireless Transmitter and
subwoofer must be no more than 50' (15 m)
apart in the room.