Paradigm DEFIANCE Série Manuel Du Propriétaire page 26

CONTROLS & CONNECTIONS:
Defiance V8 (cont'd)
6. Speaker Level Inputs (Left/Right)
The Speaker Level Inputs allows standard speaker cable be used for
the subwoofer connection. To use these connections the speaker cable
should be terminated using banana style plugs.
NOTE: The setting of the Low Pass Filter control is applied to the signal
received through these inputs.
7. Line Level Input (Left/Right)
The Line Level Input allows the Main-Out or Pre-Out be used on your
Preamp/Receiver for the subwoofer connection.
NOTE: The setting of the Low Pass Filter control is applied to the signal
received through these inputs.
8. Line Level Input (LFE)
The Line Level LFE Input allows the LFE Out/Sub-Out be used on your
Preamp/Receiver for the subwoofer connection.
NOTE: The Low Pass Filter should be set to Bypass. LFE signals are
controlled from your Preamp/Receiver.
9. AC Power Connection
The IEC power cord should be firmly inserted into the AC power
receptacle on the rear panel of the subwoofer. Then to any convenient
AC wall outlet.
NOTE: The sub also integrates a signal sensing power supply that
automatically switches off after sensing no music signal for several
minutes (this will occur when the power switch is set to 'Auto').
23
WARNING! The power cord should not be
installed, removed, or left detached from the
subwoofer while the other end is connected to
an AC power source.