Paradigm DEFIANCE Série Manuel Du Propriétaire page 3

INDUSTRY CANADA (IC) COMPLIANCE NOTICE
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation
of the device.
Any changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
Contains FCC ID: QOQBGM113 and
IC: 5123A-BGM113
Frequency Range: 2402.0-2480.0 MHz
Maximum Transmit Power: 2.5 dBm
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Per FCC regulation 47 CFR 15.21: Changes or
modifications not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
In accordance with the European Union
WEEE (Waste Electrical and Electronic
Equipment) directive effective August
13, 2005, we would like to notify you
that this product may contain regulated
materials which upon disposal, according to the
WEEE directive, require special reuse and recycling
processing. For this reason Paradigm Electronics
Inc. has arranged with our distributors in European
Union member nations to collect and recycle this
product at no cost to you.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure
limits set forth for an uncontrolled environment. End
users must follow the specific operating instructions
for satisfying RF exposure compliance. To maintain
with IC RF exposure compliance requirements
please follow operation instruction as documented
in this manual.
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
To find your local distributor contact the dealer from
whom you purchased this product, email support@
paradigm.com or visit the distributor locator at
www.paradigm.com.
Please note, only this product itself falls under the
WEEE directive. When disposing of packaging and
other related shipping materials we encourage you
to recycle these items through the normal channels.