Toyotomi FF-95 Manuel D'utilisation page 7

1. Turning Heater ON
1. Press ON/OFF switch to "ON" position. The current room temperature and the set
temperature will be shown on the digital indicator. ON lamp will start to flash and
then blower motor and ignition will start. This lamp will continue to flash during the
preheating time.
2. After approx. 1.5 – 4 minutes ignition will take place. (*) After ignition, ON lamp will
change flashing to continuous. Circulation fan will turn on after approx. 2 minutes.
NOTE: (*) Pre -heating depends on the room temperature.
Room temperature:
under 0˚C 4
0˚C - 15˚C 2
15˚C 1.5
2. Adjusting Room Temperature
1. Press "▲MIN." or "▼HOUR" button. ˚F or ˚C will start to flash.
2. Press "▲MIN." or "▼HOUR" button as required. Room temperature can be set from
10˚C (50˚F) to 32C (90˚F). (Initial setting : 13˚C (56˚F))
Desired temperature setting will be displayed on the digital indicator when you set
the room temperature.
When room temperature reaches the selected setting, heater will automatically shift
to "MED" or "LOW" burning mode to maintain the desired temperature.
When room temperature exceeds the selected setting by approx. 2˚C (4˚F), the heater
will automatically shut off. As room temperature drops, the heater will automatically
re-start to maintain the desired temperature.
POWER SAVER OPERATION
The Power Saver mode reduces the frequency of ignition actions, to save electric
consumption.
1. Press the POWER SAVER (DAY SELECT) button "ON" while in operation to start the
operation of the "POWER SAVER". "POWER SAVER" sign will be shown on the digital
indicator.
When the room temperature exceeds the selected setting by approximately 6˚C (10˚F),
the heater will automatically shut off. As the room temperature becomes lower than
the selected setting, the heater will automatically re-start to maintain the desired
temperature.
CHILD LOCK OPERATION
The childproof lock can be used to prevent children accidentally changing the heater
settings. When the heater is burning and the childproof lock is on, the heater can only be
switched off. Other functions are blocked then. If the heater has already been switched off,
the childproof lock also prevents accidental ignition of the heater.
1. Press the CHILD LOCK (CLEAR) button for more than 3 seconds to set the childproof
lock while in operation or not operation. "CHILD LOCK" sign will be shown on the digital
indicator.
To release the child lock operation, press the CHILD LOCK (CLEAR) button for more
than 3 seconds.
minutes
minutes
minutes
ENGLISH
GB
6