Wheel Washer Filling In - TECO LR400 Manuel D'instructions

4.2

WHEEL WASHER FILLING IN

WARNING
do not pour the plastic granulate into the water before positioning the segregation bulkhead.
- Remove the washing tank inspection lid on the front the wheel washer body.
- A segregation bulkhead is placed within the wheel washer body below the inspection lid to keep the granulate away from collecting on the front of
the wheel washer body and enhance the collection of the granulate by the pump.
- On the washing tank internal side a water level indicator is provided on which two arrows are present on above the other (Fig.8).
- Fill the wheel washer body through the opening of the inspection lid with clean tap water until water level reaches the lower arrow on the water
level indicator.
CAUTION
do not pour the plastic granulate into the washing tank before fi lling it with water.
- Reposition the inspection lid and open the washing chamber door.
- Position the bag containing the plastic granulate on the washing chamber door and open it.
- Pour the plastic granulate into the water within the wheel washer body through the washing chamber.
CAUTION
do not pour the plastic granulate into the water within the wheel washer body through the inspection lid, as the segregation bulkhead
would then prevent them from being collected by wheel washer pump and the washing effect of the wheel washer would be severely
impaired.
WARNING
do not pour cleaning agents other than the plastic granules approved by the manufacturer into the water.
operating the wheel washer with cleaning agents other than those approved by the manufacturer (e.g. detergents, abrasives, different
plastic granulate) may lead to excessive foam formation and spillage from the wheel washer body, unsatisfactory cleaning performance,
damages to the wheel washer or to the wheels being washed.
The manufacturer takes no responsibility for damages of any type that may arise if the wheel washer is operated with cleaning agents
other than those approved by the manufacturer.
operating the wheel washer with cleaning agents other than those approved by the manufacturer will void the warranty.
- Close the washing chamber door and remove the inspection lid again.
- Fill the wheel washer body through the opening of the inspection lid with clean tap water until the water level reaches the upper arrow on the water
level indicator.
WARNING
Filling the wheel washer body with water up to the point where the water level lays above the upper arrow may lead to pump motor over-
loading and operation disruption due to tripping of the motor protection circuit breaker protecting the pump motor from overloading and
may also lead to reduced endurance of the pump motor.
CAUTION
Filling the wheel washer body with water up to the point where the water level lays below the upper arrow will lead to reduced washing
effect.
- Reposition the inspection lid again.
8
CHECK WATER LEVEL
CONTROLLARE LIVELLO ACQUA
CONTRÔLER NIVEAU EAU
CONTROLAR NIVEL AGUA
WASSERNIVEAU PRÜFEN
H O
2
100mm
Adesivo cod. 4-602878
UNICA FUSTELLA - DUE ADESIVI SEPARATI
CHECK ROT
CONTROLLA
CONTRÔLER
CONTROLAR
DREHRICHT
PUMP
100mm
37