Switching The Internal Amplifi Er On/Off (Amp On); Resetting The Device To Factory Settings (Normset); Changing The Scan Time (Scantime) - Blaupunkt St. Louis MP56 Notice D'emploi Et De Montage

Changing basic settings in the settings menu
Switching the internal amplifi er
on/off ( AMP ON)
If you connected the device to an
external power amplifi er via the
preamplifi er outputs (Preamp),
you can switch off the internal
amplifi er of the device as follows:
CAUTION!
No sound with switched-
off internal amplifi er!
If you switch off the internal am-
plifi er, you do not hear a sound
from the loudspeakers connected
to the device!
➔
Switch off the internal amplifi -
er only if you connected an ex-
ternal power amplifi er to the
preamplifi er outputs (Preamp)
of the device and you connect-
ed your loudspeakers to this
power amplifi er:
➔
Press the softkey
"AMP ON").
The status of the internal am-
plifi er is shown on the main
A
line :
•
"INTERNAL AMP ON": The in-
ternal amplifi er is switched
on. Loudspeakers connected
to the device play back the
selected audio source.
56
8
(next to
•
"INTERNAL AMP OFF": The
internal amplifi er is switched
off. Loudspeakers connected
to the device always remain
mute. The loudspeakers must
be connected to the external
amplifi er.
Resetting the device to factory
settings ( NORMSET)
➔
Press and hold the softkey
(next to "NORMSET") for ap-
prox. two seconds.
The main line
"NORMSET ON". The device is
reset to the factory settings.
Changing the scan time
( SCANTIME)
➔
Press the softkey
"SCANTIME").
The "SCANTIME" menu item is
fl ashing. The current scan time
is shown on the main line
➔
On the rocker switch
repeatedly press
increase the scan time.
➔
On the rocker switch
repeatedly press
decrease the scan time.
You can adjust scan times in in-
crements of 5 seconds form 5 to
30 seconds.
<
A briefl y displays
;
(next to
A
.
3
,
or to
3
,
or to