Configuration - SOMFY animeo KNX 4 AC Notice D'installation

EN
A
PICTURES
[1] KNX 4 AC Motor Controller 2/3 EL WM 230 V AC,
wall mounted version
[2] KNX 4 AC Motor Controller 2/3 EL DRM 230 V AC,
DIN rail mounted version
B
MOUNTING
[1] Choose the optimal location: flat and large surface
[2] Mount the KNX 4 AC Motor Controller 2/3 EL WM
[3] DIN Rail mounted version
1.
Electrical cabinet
[4] Use cable tie!
[5] Keep to minimum distance
C
WIRING
[1] Tool for all terminals
[2] Wiring diagram
[3] Check the correct running directions of the end
product
UP: the end product goes up ( C + s)
STOP: the end product stops ( C + t+ s)
DOWN: the end product goes down ( C + t)
To close window press UP, to open window press
DOWN.
[4] Possible switches
1. Smoove Origin IB, ref. 1811272
2.
Double push button
D

CONFIGURATION

[1] Reset / Prog button
With this button, you can access the basic configu-
ration of the Motor Controller.
The „US" LED is steadily blinking when the mains (230 V)
and the KNX bus power are actively connected to the de-
vice. The device is ready for operation when the „US" LED
is blinking. The Reset / Prog button can be used to select a
switch ergonomic when the device is in default condition
and is not programmed by the ETS Software. The different
ergonomics are described in the user manual.
CABLE
Connection to ...
Motors
Switches
Group control
KNX bus
230 V AC
Cables
Min.: 4 x 0.75 mm /18 AWG
2
Max.: 4 x 2.5 mm /13 AWG
2
Min.: 3 x 0.28 mm /22 AWG
2
Max.: 3 x 2.5 mm 2 /13 AWG
Min.: 3 x 0.28 mm /22 AWG
2
Max.: 3 x 1.5 mm 2 /15 AWG
2 x 0.5 mm /20 AWG
2
Min.: 2 x 1.5 mm /15 AWG
2
Max.: 2 x 2.5 mm 2 /13 AWG
[2] Selection of switch ergonomic
Local push button ergonomics and the type of end
products to be preselected:
• Screen mode
• Venetian blind, European mode
• Venetian blind, US mode
• 3 end limit Venetian blind with EU mode
The default mode is: Venetian blind, EU mode.
1. To toggle between modes, press shortly the
Reset / Prog button. Repeat until the LED, accord-
ing to the desired configuration, lights up.
[3] Factory RESET
[4] Learn running time automatically
[5] Symbols: actions
1. Up
2. Stop
[6] Symbols: end product status
1. Up
2.
High position
3. Down
4.
Low position
End limit detection only works with mechanical motors or
with electronic motors using relays as switching elements.
Twisted pairs
-
Recommended
Recommended
Required, following KNX
topology guidelines
-
animeo KNX 4 AC MOTOR CONTROLLER 2/3 EL . REF. 5119060D -
Max. distance
100 m/330 ft
50 m/165 ft
6/12