Operation with detergent
Note
Detergent can only be added when the ap-
pliance is being operated in low pressure
mode.
All washing brushes supplied by Kärcher
are designed for use with detergents.
Use spray lance with pressure regula-
tion (Vario Power).
Turn the spray lance to "Mix" position -
low pressure.
DT take-up from container
Pull the required length of the DT suc-
tion hose from the housing.
Place the end the DT suction hose in a
container with DT solution.
Recommended Cleaning Method
1 Spray a small dose of the detergent on
the dry surface, and allow it to react
(make sure the detergent does not dry
up).
2 Wash off the loosened dirt using the
high-pressure jet.
Detergents
To ensure a trouble-free operation of the
appliance and to match the individual
cleaning task, we recommend our Kärcher
detergent and maintenance agents. Please
ask for our advice, or request information
on the products.
Interrupting operation
Release the lever on the trigger gun.
During breaks, use the safety catch to
secure the trigger gun lever.
During longer breaks (more than 5 min-
utes), also turn the appliance off using
the ON/OFF switch.
12
English
Finish operation
If detergent has been added: Suspend
detergent suction hose in a container
filled with clear water, switch the appli-
ance on for around 1 minute once the
spray lance has been removed and
rinse until water runs clear.
Release the lever on the trigger gun.
Switch the appliance switch to "0/OFF".
Turn off tap.
Press the lever on the trigger gun to re-
lease any remaining pressure in the
system.
Disconnect the appliance from the wa-
ter supply.
Detach spray lance from the trigger
gun.
Briefly switch the appliance on ("I/ON"),
press the trigger gun lever until no fur-
ther water is discharged (approx. 1
min).
Switch the appliance switch to "0/OFF".
Use the safety catch to secure the trig-
ger gun lever.
Pull out the mains plug.
Store the power cord, the HP hose and
the accessories on the appliance.