Basic Operation; Powering Off And Restarting - Tripp-Lite B004-HUA4-K Manuel Du Propriétaire

Basic Operation

Powering Off and Restarting

In the event that you need to power off the KVM switch, you must follow the steps below:
1. Shut down all computers connected to the KVM switch
2. Unplug the power supply from the KVM switch
3. Wait 10 seconds and then plug the power supply back into the KVM switch
4. Power on all of the connected computers
Port Switching
There are two ways of accessing computers and devices connected to the KVM switch:
• Manual Push Buttons
• Hotkey Commands
Manual Push Buttons
Pressing a push button will bring the focus of one of the following to the corresponding port: KVM only, USB only, Audio only, or
KVM, Audio and USB focus simultaneously. There are two sets of push-button commands, Default and Alternative, which can
be toggled between via hotkey command (see the Alternative Push-Button Command section for details).
Default Push-Button Commands
Function
Switch all focus (KVM, Audio and USB) to a
specific port
Switch KVM focus to a specific port
Switch audio focus to a specific port
Switch USB focus to a specific port
Auto Scan
*When in Auto Scan mode, press and release any of the four push buttons to stop scanning. The KVM focus will go to the port
corresponding to the push button you pressed.
Alternative Push-Button Commands
Function
Switch all focus (KVM, Audio and USB) to a
specific port
Switch KVM focus to a specific port
Switch audio focus to a specific port
Switch USB focus to a specific port
Auto Scan
*When in Auto Scan mode, press and release any of the four push buttons to stop scanning. The KVM focus will go to the port
corresponding to the push button you pressed.
Description
Press and hold the corresponding push button for 2 seconds of the
desired port you wish to switch focus to.
Press the corresponding push button once for the desired port you wish
to switch focus to.
Press the corresponding push button twice for the desired port you wish
to switch focus to.
Press the corresponding push button 3 times for the desired port you
wish to switch focus to.
Press and hold both 1 & 2 push buttons for more than 2 seconds
to initiate Auto Scan. It will cycle from port to port every 5 seconds
(default).*
Description
Press the corresponding push button once for the desired port which you
wish to switch focus.
Press and hold the corresponding push button for 2 seconds of the
desired port which you wish to switch focus.
Press the corresponding push button twice for the desired port which you
wish to switch focus.
Press the corresponding push button 3 times for the desired port which
you wish to switch focus.
Press and hold both 1 & 2 push buttons for more than 2 seconds
to initiate Auto Scan. It will cycle from port to port every 5 seconds
(default).*
7