Cleaning The Tiller; Maintaining The Chain Housing; Engine; Storage - Texas FUTURA 6003 Mode D'emploi

Cleaning the tiller

The tiller should be cleaned after use. Use a garden hose to wash off soil and dirt.
Remove any grass, etc. from the rotor shaft. The chassis number should only be cleaned
with a damp cloth, otherwise there is a risk that it might be erased. Avoid using a high-
pressure washer during cleaning.

Maintaining the chain housing

The chain housing is lubricated with 0,6 litres of TEXACO Multifak EP0 grease at the
factory. This process does not need to be repeated.

Engine

For correct use and maintenance of the engine, consult the accompanying engine manual.
Your machine is delivered assembled and has been test-started at the factory.
However, for safety's sake you should check the engine for oil before starting it.

Storage

If the machine is likely to be stored unused for prolonged periods, follow the instructions
below. This will ensure the machine has a long service life.
Use a garden hose to wash off soil and dirt. Remove any grass, etc. from the rotor shaft.
The chassis number should only be cleaned with a damp cloth, otherwise there is a risk
that it might be erased. Avoid using a high-pressure washer during cleaning.
Wipe the tiller over with a damp cloth so that all surfaces are clean. Wipe the surfaces
down with an oily cloth to prevent rust.
You should always store your machine in a dry, clean place.

Accessories

Figures 4-6 show the assembly of accessories, horn attachment, front ballast weight,
swivel plough, wheels and wheel weights.

Troubleshooting

The engine won't start: 1. Check that the start/stop button is correctly set.
2. Check that the spark plug is not defective.
3. Check that the spark plug socket is fitted correctly.
4. If there is a fuel valve, check that this is open.
5. Check that the choke is open.
6. Check the engine manual for further
troubleshooting advice.
21