Clothing; Use - Texas FUTURA 6003 Mode D'emploi

4. Figure D.
Mount the tiller blades with the supplied cotter pins and bushings (Figure B, 3, 7, 6).
Use cotter bolts for mounting inner blades (Figure B, 5)
It is important that the cutting edge of the tiller blade is turned toward the front as
shown in Figure D 1.
5. Figure E/F.
Mount wheel on wheel bracket as shown. Incorrect assembly is shown in Figure E.
6. Figure G.
Mount complete wheel bracket assembly as shown.
7. Figure H.
Mount rear console onto the enclosed U-bracket as shown.
Use the supplied bolts, Figure B, I.
8. Figure I.
Mount rear console with the supplied cotter bolts and cotter pins, Figure B, 2.
9. Figure I.
Mount debth skid on rear console as shown.
10. Figure J.
Mount side guards as shown. Use the supplied screws and nuts, Figure B, 4.
11. Fill up with fuel and oil according to instructions in engine manual.

Clothing

When using the machine, wear close-fitting
work clothes, tough working gloves, ear
defenders and non-slip boots with steel
toecaps.

Use

Before using the machine, remove all foreign objects from the area. Stones, glass,
branches and similar items can damage the tiller. Also check that bolts on the tiller are
tightened.
Start:
Set the throttle to fully open. (Figure 2, A)
Set the engine ignition switch to "ON".
Set the choke lever on the engine to "Choker"
If the engine is mounted with a fuelvalve, switch to "ON"
Once the engine is running, adjust the engine speed by moving the choke arm on the
engine to "RUN".
Do not overload the tiller. Always use it with care.
18