Disposal; Removing The Battery; Faults - Kärcher BR 35/12 C Bp Mode D'emploi

 Insert the holder with the vacuum lips
into the vacuum bar and snap into
place.
Replacing the brush roller
WARNING
Risk of crushing due to the parking stand
folding up during the brush replacement.
Turn the steering wheel by 90° to the left
prior to the brush replacement.
 Press the release button for the brush
roller and swivel the brush roller toward
the bottom and pull it off the driver.
 Place the new brush roller on the driver
and lock into place on the opposite side.
Maintenance contract
To ensure a reliable operation of the appli-
ance maintenance contracts can be con-
cluded with the competent Kärcher sales
office.

Disposal

Removing the battery

DANGER
The removal of the battery may only be per-
formed by the Kärcher aftersales service or
a specialist.
DANGER
Risk of injury. Turn the appliance switch to
"0" and pull the mains plug of the charger
prior to performing any work on the appli-
ance.
ATTENTION
Fault
Appliance cannot be started
Insufficient water quantity
20
The evaluation, whether the battery is dam-
aged or not, is done by an authorised after-
sales technician
The Chapter "Safety instructions" for han-
dling accumulators must be observed un-
conditionally.
1 Screw
2 Cover
 Unscrew 2 screws.
 Swivel the lid downwards.
 Loosen and remove the battery plug.
 Remove the battery.
 Dispose of used battery in accordance

Faults

Risk of damage for the appliance due to
leaking water. Drain the wastewater and re-
maining fresh water prior to performing
tasks on the appliance.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
Remedy
Switch on the appliance switch, wait 3 seconds, check
charge condition of the battery.
Check fresh water level, refill tank if necessary.
Switch on "Detergent" button.
Open the dosing device for the cleaning solution.
Clean the fresh water filter.
EN – 8
with the applicable provisions.