How To Set The Timeout Lock In Admin Mode - iStorage datashur PRO Manuel D'utilisation

19. How to set the Timeout Lock in Admin mode

To protect against unauthorised access when the datAshur PRO is connected to a host and unattended, the datAshur PRO can
be set to automatically lock after a pre-set amount of time.
In its default state, the datAshur PRO Timeout Lock feature is turned off. The Timeout Lock feature can be set to
activate (lock) anywhere between 1 and 99 minutes. Admin Timeout Lock settings will override User settings.
To set the Timeout Lock please follow steps in the table below.
Caution: Entering the Admin PIN to access a locked drive will clear the User PIN. For security reasons, we
highly recommend that a new User PIN be created immediately once the drive has been unlocked
using the Admin PIN. Refer to section 13 on page 12.
Instructions
1. Unlock the datAshur PRO with Admin PIN
2. Press the KEY button 3 times
(treble click)
3. Within 10 seconds begin to press button number 8
(Tuv) followed by the number 5 (jkL) button - (85)
4. Press KEY button once
5. Within 10 seconds begin to enter the length of User
Timeout in 2 digits:
00 = 0 minutes (default)
01 = 1 minute
99 = 99 minutes etc
6. Press the Key button once
#16
LED LED State
Red solid LED followed by a flickering
LED indicating successful Admin PIN entry
Green
&
awaiting new instructions in OPTIONS mode.
Green
&
together
Blinking
Green
Red solid LED changing to flickering
LED. Admin can override USER Lock Timeout
www.istorage-uk.com www.istorage-uk.com
and Blue LED's flicker together
and Blue LED's continue to flicker
Green LED
LED continues to blink
Green
Green
#16