Technical Data; Accuracy; Ambient Conditions; Supply Voltage (External) - Balluff BTL5-T1 -M Série Manuel D'instructions

BTL5-T1 _ _ -M _ _ _ _ -A/B/Y/Z-S103
Transducer – Rod Style
6

Technical data

6.1

Accuracy

The specifications are typical values for the BTL5-T... at
24 V DC and room temperature, with a nominal length of
500 mm in conjunction with the BTL-P-1013-4R,
BTL-P-1013-4S, BTL-P-1012-4R or BTL-P-1014-2R
magnet.
The transducer is fully operational immediately, with full
accuracy after warm-up.
For special versions, other technical data may
apply.
Special versions are indicated by the suffix -SA
on the part label.
Position resolution
Non-linearity
Hysteresis
Reproducibility
Temperature coefficient
1)
Velocity resolution
Max. detectable velocity
6.2

Ambient conditions

Operating temperature
Storage temperature
Humidity
Rod pressure rating (when
installed in hydraulic cylinders)
Shock rating
Continuous shock
per EN 60068-2-27
3)
Vibration
per EN 60068-2-6
3)
(note resonant frequency of the
rod)
Degree of protection per
IEC 60529
when attached
14 english
5 µm
±30 µm
≤ 1 LSB
≤ 2 LSB
≤ (6 µm + 5 ppm
x nominal length)/K
0,1 mm/s
10 m/s
2)
−40°C...+85°C
−40°C...+100°C
< 90%, non-
condensing
< 600 bar
100 g/6 ms
100 g/2 ms
12 g, 10...2000 Hz
IP67
6.3

Supply voltage (external)

Voltage, stabilized
4)
Ripple
Current draw (at 24 V DC)
5)
Inrush current
Reverse polarity protection
Overvoltage protection
Dielectric strength
(GND to housing)
6.4

Control signals

RxD/TxD-N, RxD/TxD-P, Data GND per EN 50170
6.5

Output

Max. number of magnets
Nominal length 500 mm, magnet in the middle of the measuring range
1)
For : Use in enclosed spaces and up to a height of 2000 m above sea
2)
level.
3) Individual specifications as per Balluff factory standard, resonant
frequencies excluded
4) For : The transducer must be externally connected via a limited-
energy circuit as defined in UL 61010-1, a low-power source as defined in
UL 60950-1, or a class 2 power supply as defined in UL 1310 or
UL 1585.
Depending on the load on VP (repeater, bus termination)
5)
6) Number dependent on nominal length (see section 3.3)
20...28 V DC
≤ 0.5 V
ss
≤ 130 mA
≤ 3 A
Yes
Yes
500 V DC
4
6)