Cleaning And Maintenance - Boneco S150 Instructions D'utilisation

Turning the device on
• Insert plug into mains socket.
• Use the ON/OFF switch to turn the device on.
en
NO WATER
NORMAL
B
ECO
POWER
A
A) ON/OFF switch with indicator light
«POWER»
• Green LED is illuminated when device is switched on.
B) Setting switch for two levels:
« » High humidity output (NORMAL)
« » Low humidity output (ECO)
14
After use
• Use the ON/OFF switch to turn the device off.
• Remove the plug from the mains socket.
• Wait until the device has cooled fully.
• Empty any remaining water and rinse the water tank
thoroughly.
Clean and maintain the device regularly to ensure that it
operates hygienically and smoothly.
• Weekly: Clean housing parts and water tank.
• Depending on quantity of limescale: descale Calc Ball
HUMIDIFY
and vaporizer board (see «Cleaning and maintenance»).
• Annually: clean the device after the heating season.
• Ensure the device is allowed to dry fully before putting
it into storage.
POWER

Cleaning and maintenance

Remove the plug from the mains before cleaning,
maintaining, descaling or rinsing the device.
ON OFF
• Allow the device to cool fully.
• Never immerse the basic device (including the cable) in
water or any other liquid.
• Empty any remaining water from the device and water
tank and rinse the water tank thoroughly.
• Lift up the cover for the vaporizer unit to remove it.
• The Calc Ball absorbs a large proportion of the lime-
scale particles. It hinders calcification by moving
across the vaporizer board. Depending on the level
of limescale, the Calc Ball needs to be cleaned at
regular intervals (immerse the Calc Ball completely in
limescale-remover).
• The vaporizer board also needs to be descaled on a re-
gular basis. Creates steam when in operation: Warning!
Hot! If limescale deposits form around the vaporizer
board, descale the device with domestic limescale-
remover (mixing ratio limescale-remover: water = 2:1).
To do so, apply limescale-remover to the black vapo-
rizer board (avoiding any plastic components!). After
the limescale remover has taken effect, use a cloth to
remove any residue and then wipe the vaporizer board
dry. Important: do not use any abrasive implements
(knives etc.) or scouring pads as this damages the
non-stick coating!
• Clean the housing with a damp cloth then wipe it dry.
Notes on how a steam humidifier works
• In the steam humidifier principle, the vaporizer board
heats up the water to the boiling point so that it vapori-
zes.
• Humidity is heavily restricted by circulating air
(for example, in rooms with open/poorly sealed
windows or in elevated rooms).
• Please note that humidity rises with warm air and this
can cause unwanted condensation in some areas.