Technical Specifications - Hudora 14599 Instructions De Montage Et Mode D'emploi

INSTRUCTIONS ON aSSEMBLY aND USE
EN
CONGRaTULaTIONS ON PURCHaSING THIS PRODUCT!
Please read these instructions carefully. The instructions are an integral component of the product.
Therefore, please store them and the packaging carefully in case questions arise in the future. Please
always include these instructions when handing on the product to a third party. This product must be
assembled by an adult. This product is not designed for industrial use. The use of the product requires
specific skills and knowledge to be able to avoid injuries due to crashes and collisions. Always adjust
according to the age of the user and use for the purpose it has been designed for.

TECHNICaL SPECIfICaTIONS

Article: HUDORA Scooter L205 with light
Article number: 14599
Dimensions: approx. 85 cm long, tread approx. 27 x 12 cm
Weight: 4,7 kg
Maximum user weight: 100 kg
If you have assembly problems or would like further information on the product, we have all you need
and more at http://www.hudora.de/.
CONTENT
1 x scooter, 1 x user guide
Other parts which may be supplied are not essential.
SafETY INSTRUCTIONS
• The scooter is only intended for use by one person.
• Only use the scooter on surfaces that are suitable for it, i.e. those which are flat, clean, dry, and
use the scooter where possible away from other road users. Avoid sloping ground. The brakes
may become hot if the scooter has been used for a while! They shouldn't be touched until they
have cooled down.
• Always be considerate of others.
• Wear suitable protective clothing for your own safety. Never use the scooter without a helmet and
hand/wrist, elbow and knee pads. Never use the scooter without shoes!
• Before you begin – Ensure that all fasteners and locking parts are intact and tight, e.g. the folding
mechanism and the height setting of the handlebar. The functions of self-securing screw threads
can be impaired after repeated loosening and tightening of the connecting elements. Check
especially for the correct alignment and fastening of the steering set-up.
• Do not use the scooter at twilight, at night or in poor visibility. Do not use it on roads or thorough-
fares or on slopes or hills. Avoid being in the proximity of stairs and open water.
• The scooter is not suitable for jumps.
• The scooter is not a vehicle in the sense of the road traffic regulations! It is intended for use on
footpaths.
• Warnings! Protective equipment should be worn (helmet). Not to be used in traffic. 100 kg max.
INSTRUCTIONS ON aSSEMBLY
No tools are needed for assembly. The scooter will be delivered in transport condition (folded)!
(Picture 1)
IN ORDER TO MaKE THE SCOOTER REaDY fOR USE, PLEaSE PROCEED aS
fOLLOWS
• Open the quick-release lock at the front end of the running board by turning the grey lever
downwards to release the transport lock (Picture 2)
• Press the steering column forwards until you hear it lock in at an angle of approx. 90° (Picture 3).
• Guide the handlebar grips onto the T piece of the steering column. Press both locking buttons
with your thumb until the handlebar grips can be pushed onto the T piece without difficulty. Turn
the handlebar grips until the locking buttons appear in their locking holes and you hear them snap
in. Check that both handlebar grips are positioned correctly by pulling them both out. They are
correctly installed once they can no longer be moved (Picture 4),
• The steering column can be locked at 2 heights. Pull the steering column out of the steering shaft
until the steering column has reached the height required and the appropriate push button is
locked in (Picture 7).
• The built-in security device prevents the steering column being pulled out beyond the maximum
height. Should the steering column not be fixed firmly enough at the required height, open the
quick-release fastener again and tighten the screw on the other side so that the clamp sits more
firmly against the steering column. (Picture 5) Repeat this process until the steering column can
be adjusted safely (Picture 6).
• Now close the quick-release fastener by pushing the lever down against the steering shaft.
• Always check that all parts are firmly fixed before use, especially the folding mechanism, the
steering lock mechanism and the wheels.
• The play in the components can increase after some time. If required, re-tighten the screw
in Picture 8.
PLEaSE PROCEED aS fOLLOWS TO RETURN THE SCOOTER TOTRaNSPORT
CONDITION
• Open the quick-release fastener by pushing the lever away from the steering shaft.
• Press the locking button so that the steering column can be moved (Picture 7).
• Push the steering column into the steering shaft as far as it will go.
• Close the quick-release fastener by pushing the lever down against the steering shaft.
• Press the locking buttons in the handlebar grips with your thumbs and pull the handlebar grips
outwards until they are completely released from the T piece (Picture 4).
• Push the handlebar grips down until they are parallel to the steering column and lock into the
handlebar mount.
• Pull up the lever to release the transport lock. (Picture 9)
• Fold the scooter by turning the steering column towards the rear wheel until you hear the
transport lock snap in. Ensure that the transport lock is latched before you transport the scooter.
INSERT aND CHaNGING THE BaTTERIES
• 4x AA batteries are needed for the illumination to work. The batteries are not included. These
batteries are widely available in retail outlets.
• To insert the batteries, turn the scooter until you have good access to the battery panel beneath the
base plate. (fig. 1)
• Loosen the screw of the battery cover and take it out. You will need a Phillips screwdriver (not
included) to remove the screw. (fig. B)
EN 14619
All images are examples of the design.
• Insert the batteries respectively change them, making sure that the polarity is correct (fig. C).
• Screw the battery cover firmly closed.
• Press the button once to switch on the scooter light. Press it a second time to switch the light off
(fig. A).
SWITCHING ON THE LIGHT
• Turn the scooter so that you can easily reach the red on/off button under the footplate (fig. A)
• Press the button once to switch on the scooter light. Press it a second time to switch the light off
(fig. A).
• The scooter light will also switch on when you activate the foot brake. Please note that this will
also happen when the light is switched off.
BaTTERIES REQUIRED
4xAA
Nicht im Lieferumfang
Never try to charge non-rechargeable batteries. If attempts are made to charge this type of battery,
they may not only run out but also explode, which may lead to destruction, the risk of fire and not
least to injuries. Rechargeable batteries must be removed from the scooter before charging. Make
sure that rechargeable batteries are only charged under adult supervision. Use only the batteries
specified in the scooter. Please remove empty batteries from the scooter and dispose of them in
an environmentally appropriate manner. Do not combine used and unused batteries in the scooter.
Remove the batteries when the scooter is not in use.
USaGE INSTRUCTIONS
NOTHING'S EASY AT FIRST ...
... most accidents happen to "beginners" within the first ten minutes. Particular care should be taken
during this stage.
DRIvING INSTRUCTIONS
The scooter moves when a foot is used to regularly push off, just as with well-known children's
scooters. Braking is no problem either - simply step on the friction brake over the back wheel
(mudguard).
We recommend folding the scooter by hand after each use.
Aluminium is a good and light material but should also be handled carefully as it is not as hard as
steel, for example.
MaINTENaNCE aND STORaGE
Use a dry or damp cloth only to clean the product; do not use special cleaning agents! Check the
product for damage or traces of wear and tear before and after each use. Do not make any structural
changes. For your own safety, please use original spare parts only. These can be sourced from
HUDORA. If parts become damaged or if sharp edges or corners should develop, the product may not
be used any more. If in any doubt, please contact our service team (http://www.hudora.de/). Store
the product in a safe place where it is protected from the elements, cannot be damaged, and cannot
injure anyone.
CHANGING THE WHEELS
Replacement wheels are available as accessories from http://www.hudora.de/ and should be
replaced when they get worn down. To change the wheels, loosen the axle screw using two Allen
keys (size 5) and take the wheel off the axle. You can push the bearing out of the wheel using a
screwdriver or Allen key to continue using it in the new wheel. However, it is usually advisable to
change the bearing at the same time as the wheel. Reinsert the bearing with the spacer sleeve in the
new wheel and mount on the frame with the axle screws. Make sure that the axle is tightly screwed
before you start off again!
BEARINGS
Your scooter is equipped with precision bearings which were filled with grease at high pressure during
manufacture. For this reason, the wheels will only run lightly and quickly when weight is placed upon
them. The bearings do not need maintenance. If a bearing is knocked out, it should be replaced
completely. Bearings are available as accessories at http://www.hudora.de.
DISPOSaL INfORMaTION
At the end of its useful life, please take the device to the available return and collection
systems. The disposal company will answer questions on site.
SERVICE
We make every effort to deliver faultless products. If faults do arise however, we put just as much
effort into rectifying them. Therefore, you can find numerous information on the product, replacement
parts, solutions to problems and lost assembly manuals at: http://www.hudora.de/
HUDORA I Jägerwald 13 I 42897 Remscheid I Germany
www.hudora.de
Not supplied
enthalten
IMPORTaNT NOTE ON DISPOSING Of BaTTERIES aND
aCCUMULaTORS
According to German battery legislation, all consumers are obliged to return all used and
empty batteries and accumulators. It is forbidden to dispose of them via the house waste. Old
batteries and accumulators can be handed in free of charge at municipal public collection
points and everywhere where batteries and accumulators of the relevant type are sold.
Item no. 14599
As of 11/11
Page 4/8