On/Off Switch - L-Acoustics LA8 Manuel Utilisateur

6.5

On/Off Switch

When the controller is switched on (Figure 8) a 20 second start-up procedure of internal tests is activated, as described
in section 7.4.1. The controller is ready for use when the LCD displays the main screen (see section 7.2).
When the amplified controller is switched Off the LCD flashes the ''POWER OFF'' message for several seconds until
complete shut down.
EN
Notes: In case of power loss the controller will restart automatically once the power has been restored, and reboot to
the exact same state prior to power loss.
The ''Standby Mode'' message (and the four LOAD LEDs lit [see section 7.5.1]) indicates that the controller has been
put in the Standby Mode via the LA NETWORK MANAGER software. This standby status prevents any front panel
control and operating. To cancel the Standby Mode and LA NETWORK MANAGER exclusive control, reboot the unit
by switching it off and on again.
The On/Off switch does NOT disconnect the amplified controller from mains.
VOLTAGE
Off
On
Figure 8: The On/Off switch
w w w . l - a c o u s t i c s . c o m
LA8_UM_ML_1.2 17 en