Dometic RM 8501 Consignes D'installation page 17

S+ − connection :
on the appliance
on the vehicle
Cable cross−sectional areas :
There are no particularly high current flows via
the D+ and S+ connection; therefore no particu−
Switch−over time within the individual energy modes in automatic mode:
Gas
~2-5 s
230V
D+ S+
Fig. E33
~2-5 s
~2-5 s
~2-5 s
~2-5 s
~2-5 s
~2-5 s
12V DC energy can be optionally achieved by
mounting solar equipment to the vehicle. The
solar power equipment must be provided with a
solar charging controller with AES output (ade−
quate charging controllers available in selected
stores). The "S+ connection (Solar +) must be
connected to the respective terminal of the solar
charging controller (AES output). The electronic
system uses the S+ signal of the solar charging
controller to detect solar 12V DC.
larly large cross−section is required for these
connections (approx. 0.04
12V Solar
~2-5 s
15 min
12V DC
17
˛ is sufficient).
"
~2-5 s
Fig. E34