Fronius Acctiva 12-10 Nass und Gel Instructions De Service page 32

Troubleshooting
Troubleshooting
„Final/conservation charging" indicator has been flashing for more than 12 hours
Cause:
Remedy:
Indicators not lighting up
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Charger buzzing, no indicators
Cause:
Remedy:
If the fuse trips due to the charger terminals being connected to the wrong poles, replace
Replacing the
fuse fuse as follows:
1.
2.
3.
4.
5.
Important! Reserve fuses are located in the reserve fuse holder on the rear of the
charger.
Charger lead faulty or break in lead
Check charger lead and replace if necessary
No mains supply available, charger not connected to mains, or
mains lead faulty
Check mains supply, replace faulty mains lead if necessary
Charging terminals connected to wrong poles, fuse has tripped
Replace fuse (see section „Replacing the fuse"). Connect charging
terminal poles correctly
incorrect voltage selected (Acctiva Classic)
Check setting of „Current and voltage" selector switch and correct if
necessary
Short circuit of charger leads or battery
Check charger lead and battery and rectify fault
Unplug machine from the mains
Disconnect charger leads from battery
Unscrew fuse holder cap (2)
Replace fuse
Screw fuse holder cap back in place
6