Dometic Waeco DC-Kit4 Instructions De Montage Et De Service page 28

Installing and connecting the DC Kit
7.5 Connecting the FJ1100, FJ1700, FJ2200, FJ2600,
FJ3200 Dometic roof air conditioner
➤ Remove the outlet panel of the roof air conditioner, if necessary also
remove the upper cover ( FJ1100, FJ1700, FJ2200, FJ2600, FJ3200)
(fig. 4, page 4).
➤ Join on/off cable for FJ1100, FJ1700, FJ2200, FJ2600, FJ3200 to the
plug connector on the circuit board (fig. 5, page 4).
I
NOTE
Guide the on/off cable carefully past the fan.
➤ Join the universal connection cable to the on/off cable of the FJ1100,
FJ1700, FJ2200, FJ2600, FJ3200.
➤ Connect the universal connection cable with connections I2 and I5 of the
charging current distributor ( ECL-102) (fig. 1, page 3).
➤ Attach the outlet panel of the roof air conditioner ( FJ1100, FJ1700,
FJ2200, FJ2600, FJ3200) (fig. 4, page 4).
➤ Run the connection cable of remote control MCR-9 to the inverter and
connect ( MSI2312T).
7.6 Connecting the DC Kit to the power supply
➤ Check that all the connections have been made in accordance with the
instructions.
➤ Check that the roof air conditioner is closed properly.
➤ Connect the electrical connections of the components ( ECL-102).
➤ Connect the positive battery cables to the batteries.
➤ Check the following are working properly:
– Check the on and off values for the charging voltage regulator
– Check the priority circuit
– Switch on the air conditioning in driving mode ( air conditioning)
– Switch on the air conditioning on mains operation
28
DC-Kit4
EN