Connection Of Control Elements; Optional Safety Switches - ALUTEC Special 802 Mode D'emploi

6. Installation
6.5

Optional safety switches

Reference:
i
The correct method for connecting
further safety switches (cable slack
switch, wicket door contact, etc.) is
described in the relevant instruction
manuals.
Manual for installation and operation, Special 802, 803 GB (#81811)
6.6 Connection of control
elements
Attention!
To prevent damage due to moisture
on the closing edge safety device,
the cable connections must always
be inserted from the underside of the
housing.
To prevent malfunctions, a shorting
plug or a wire jumper must be inser-
ted for the closed circuit system in
any connection terminals that are not
used (XP40A, XP41, XP41A, XP41B).
69