Preparation For Mounting - ALUTEC Special 802 Mode D'emploi

5.

Preparation for mounting

Attention!
In order to guarantee correct
mounting, carry out the following
checks before installing.
Supply package
• Check the package to ensure that all the parts
are included.
Door system
Attention!
In order to ensure that the device
functions correctly, the closing edge
safety device is only to be mounted
when the door and the drive are
completely assembled.
Reference:
i
Please observe the safety information
in the corresponding door and drive
instructions concerning mounting
and operation.
Advice:
- The following assembly drawings
are an example. Depending on the
structural conditions and the door
type, differing installations could be
required.
- The lengths of the cables for the
optosensors and the cable slack
switches have to be taken into
consideration during the installation.
Manual for installation and operation, Special 802, 803 GB (#81811) 61