ALUTEC Special 802 Mode D'emploi page 58

3. General safety advice
Please read carefully!
Information on installing
• Ensure that the door is in good mechanical condition.
• Ensure that the door can stop in any position.
• Ensure that the door can be easily moved in the OPEN and CLOSE directions.
• Ensure that the door opens and closes properly.
• Before commencing cabling works it is very important to disconnect the operator system from the
electricity supply.
Ensure that the electricity supply remains disconnected throughout the cabling works.
• Adhere to the local protection regulations.
• Lay the electricity supply cables and control cables; these MUST be laid separately.
The controls voltage is 12 V DC.
Information on servicing
To ensure proper operation, the following items must be checked regularly and repaired if necessary.
Before any works to the door system are undertaken, the operator system must be disconnected from
the mains.
• Check the closing edge safety device regularly to ensure that it functions properly.
• Damage to the bottom door seal could obstruct the optical systems, which could result in them being
triggered prematurely.
Information on cleaning
Never use water jets, high pressure cleaners, acids or bases for cleaning.
58 Manual for installation and operation, Special 802, 803 GB (#81811)