Mounting The Receiver; Completing The Installation - ALUTEC Special 802 Mode D'emploi

6. Installation
6.4.3

Mounting the receiver

Advice:
To ensure that the closing edge
safety device functions properly, the
optosensor receiver (G) must be
constructed on the same side of the
door as the controls.
6.4.3 / 1
B
Depending on the size of the chamber (B), the
optosensor receiver (G) must be inserted with an
adapter (C).
• Insert the preassembled unit into the bottom
door seal such that the optosensor receiver (G)
is in the lower chamber and the system cable (E)
is in the upper chamber.
68
E
C
G
6.4.4

Completing the installation

6.4.4 / 1
F
• Feed the connection cable and the system
cable (E) through the specially prepared opening
in the upper chamber of the bottom door seal.
• If there is no special opening in the bottom
door seal, an opening must be made at a
distance of 8 cm from the outer edge.
Manual for installation and operation, Special 802, 803 GB (#81811)
E
D