Mounting The Transmitter - ALUTEC Special 802 Mode D'emploi

6. Installation
6.4.2

Mounting the transmitter

6.4.2 / 1
D
• Push the vent hose (D) onto the optosensor
transmitter (A).
Manual for installation and operation, Special 802, 803 GB (#81811)
A
Advice:
To ensure that the closing edge
safety device operates correctly, the
optosensor transmitter (A) must be
connected on the opposite side of
the door from the controls.
6.4.2 / 2
E
F
C
A
Depending on the size of the chamber (B), the
optosensor transmitter (A) must be inserted with
an adapter (C).
• Feed the system cable (E) and the vent hose (D)
of the optosensors through the cable gasket (F).
• Insert the preassembled unit into the bottom
door seal such that the optosensor transmitter (A)
is in the lower chamber and the cable
gasket (F) is in the upper chamber.
D
B
67