Mounting The Housing To The; Mounting The Coiled Cable - ALUTEC Special 802 Mode D'emploi

6. Installation
6.2 Mounting the housing
to the door leaf
Advice:
If the door system is to function
properly, the following points must
be assured:
- The housing connection unit (A) has
to be mounted on the drive side.
- If the connection unit is for both
sides, the housing extension unit (B)
must be mounted on the opposite
side from the controls.
6.2 / 1
A
B
A Housing connection unit
B Housing extension unit
6.2 / 2
• Screw the housing units onto the side of the
bottom of the door leaf.
64
6.3

Mounting the coiled cable

Attention!
In order to avoid damage to the coiled
cable, the following points must be
observed:
- The coiled cable must be fixed at a
- The coiled cable must hang free
Manual for installation and operation, Special 802, 803 GB (#81811)
height equal to half the door height.
after mounting.