Install Ductwork; Prepare The Installation - Broan Elite E661 Guide D'installation

1. INSTALL DUCTWORK

Plan where and how the ductwork will be installed.
Install proper-sized ductwork, elbows and roof or wall cap. Use 2" duct tape to seal duct joints.
The minimum hood distance above cooktop must not be less than 24". A maximum of 30" above cooktop is
highly recommended for best capture of cooking impurities.
Distances over 30" are at the installer and users discretion.
Roof cap
Wall
cap
HH0048A

2. PREPARE THE INSTALLATION

Make sure that the following items are included:
- Hood
- Accessories:
• Filters (2 for 30'' and 36'' width hoods, 3 for 42'' width hood)
• Plastic diverter (assembled in hood)
• 3¼" x 14" adapter/damper (inside one filler)
• Bag of parts (inside one filler) including:
(1) wire clamp, (5) #8 x ½" screws, (2) wire connectors and (3) #6 x ½" standard screws
Parts sold separately:
- Halogen lights (MR16, GU10, 120 V, 50 W)
- Transition 3¼" x 14" to 8" round model #459 (optional), transition 3¼" x 14" to 7" round model #T460 (optional),
adaptor 3¼" x 14" to 3¼" x 10" model #T461 (optional) ducts, elbows, dampers, wall or roof caps.
NOTES: 1. During installation, protect countertop and/or cooktop.
2. If the bottom of the cabinet is recessed, attach four 1'' wide wood strips (not included), as shown below,
in order to properly attach the hood to the cabinet. The wood strips must be as thick as recess.
3¼" x 14" duct OR
3¼" x 10" duct
3¼" x 14" to
3¼" x 10" adaptor
model T461 (optional)
Hood
24" minimum above
cooking surface
CABINET BOTTOM
1"
1"
10¼''
1 ¾ ' '
HO0028A
Wall
cap
HH0049A
1"
1"
5¼''
1 ¾ ' '
- 4 -
Roof cap
7" OR 8" round duct
Transition model 459
3¼" x 14" to 8" OR
model T460
3¼" x 14" to 7"
Hood
24" minimum above
cooking surface