Hella Rallye 1000 FF Instructions De Montage page 9

Electrical connection,
see illustration on page 3:
Install relay (Hella Part No. 12V:4RA
003 510 361 or 24V:4RA 003 510-
651) with connection terminals
pointing downwards so that they
are protected against splashing
water.
Final installation,
see illustration on page 4:
Fig. 4: Screw lamps to vehicle (use
two-point mount if required).
Fig. 5: Align lamps and tighten
screws
Reconnect earth lead (-) to battery.
Check lights, tighten connection
wires securely.
9
If required, install switch in
dashboard.
Disconnect earth lead (-) from
battery for safety.
Lay and connect wires according to
circuit diagram (page 3).
According to circuit diagram
auxiliary lamps are switched on
Have the driving lamps adjusted
at a workshop or service station.
Only properly adjusted lamps
provide optimum illumination.
together with the existing main
beams.
According to circuit diagram
auxiliary lamps can be switched on
in addition to the main beams with a
separate switch.
The positions lights are switched on
I the together with the parking lamps in
both circuit diagrams
One more tip:
Keep the lenses clean. Dirt can
absorb up to 80% of the light.
You drive more safely when you
can see and be seen well. Do
you have spare bulbs and fuses
in your vehicle?
If you have any questions or
installation problems: Contact
your Hella stockist.
II the