Tools Required - Hella Rallye 1000 FF Instructions De Montage

Accessories, see illustration
8
on page 2.
(not included with kit)

Tools required

• Ruler
B
A
D
B min.
A min.
(mm)
(mm)
D
1.500
350
Mounting steps, see
illustrations on page 4
3/11
1. Bulb
2. Bulb for position light
• Combination pliers
• Pliers for crimp connectors
(if available)
When mounting auxiliary lamps
with integrated position light it is
necessary to observe certain
mounting dimensions. If these
statutory mounting regulations are
B
not observed, or if the use of an
additional pair of position lamps is
C not permissible CH , A , do not
operate the position lights.
C min. D min.
(mm) (mm) Leave the lamp socket in the
auxiliary lamp to prevent leakage.
400 600
Lamps should not vibrate or extend
above the bonnet and must be
attached symmetrically.
Determine mounting position on flat
surface (left illustration) and mark
mounting points.
Ø
Drill pilot hole with 3 mm dia. bit and
then bore out to 11 mm.
mm
Protect drilled metal parts with rust
protection paint.
3. Switch 5. Two-point mount
4. Relay 6. Adapter mounting set
• 17 mm open end or box wrench
• Drill with 3, 11 and 12 mm dia. bits
• 3 and 6 mm Allen keys
Statutory operating approval in
various countries:
D
A
CH NL
GB
permissible according to law
not permissible according to law
Fig. 1: Preliminarily install mount.
Fig. 2: Open housing and install bulb
(Hella Part No. 12V 8GH 002 089-131
or 24V 8GH 002 089-251).
Install bulb for position light (12V
8GP 002 067-121 or 24V 8GP 002
067-241). Do not touch
bulbs with bare fingers! Use tissue
paper or similar.
Fig. 3: Assemble housing.
Screw holder and housing together
and route cable cleanly.
F E
S I
FIN