Adjusting The Rinse-Aid Dispenser Setting; Adding Detergent - hestan KDW Mode D'emploi

OPERATION

ADJUSTING THE RINSE-AID DISPENSER SETTING

The rinse-aid dispenser can be set to one of 6 different levels. The dishwasher is factory set for
EN
medium water hardness (selector set to "3"). To change the setting, turn the dispenser selector
(see previous page) to the desired position: the amount of rinse-aid dispensed is proportional to
the position of this selector. Make sure that the minimum amount of rinse-aid (selector turned
to "1") is approximately 1 ml and the maximum amount (selector turned to "6" ) is approximately
6 ml.
TO ADJUST THE RINSE AID SETTING:
1. Rotate the dispenser cover a quarter turn in a counter clockwise direction and remove it.
2. Use a screwdriver to rotate the rinse aid selector to the desired position.
3. Replace the cover by turning it clockwise until it is fully closed.
• The amount of rinse-aid must be increased if the washed dishes appear dull or have circular
stains.
• If, on the other hand, the dishes are sticky or have white streaks, it is necessary to reduce the
rinse-aid setting.

ADDING DETERGENT

DO NOT INHALE OR SWALLOW DETERGENT AS THIS MAY CAUSE BURNS AND/OR
PERMANENT DAMAGE TO THE NOSE, MOUTH AND THROAT, AND EVEN LEAD TO
SUFFOCATION; KEEP DETERGENT AWAY FROM YOUR EYES. IF ONE OF THE ABOVE
SITUATIONS OCCURS, SEEK MEDICAL ASSISTANCE IMMEDIATELY.
PREVENT CHILDREN FROM COMING INTO CONTACT WITH DETERGENT;
KEEP THEM AWAY FROM THE DISHWASHER WHEN THE DOOR IS OPEN AS IT MAY
CONTAIN DETERGENT RESIDUES. FILL THE DISH WASHER JUST BEFORE STARTING THE
WASHING CYCLE AND THEN KEEP THE DETERGENT OUT OF THE REACH OF CHILDREN.
To open the detergent dispenser cover, lightly press the release tab.
Add the detergent and close the cover carefully, pushing down on the arrow on the cover. During
the washing cycle, the dispenser will open automatically.
20
©2019 Hestan Commercial Corporation
(CONT.)
Dispenser release tab