hestan KDW Mode D'emploi page 16

OPERATION
PROGRAM RUN PROJECTION INDICATOR
When a program is running, a flashing light is projected onto the floor under the right-hand
EN
corner of the door.
• If the program is selected but not running, the light will be steady ON.
At the end of the program, the light goes out.
INTERRUPTING A WASH CYCLE
To interrupt a wash cycle, open the dishwasher door. The cycle will be interrupted, the cycle's
indicator lights will flash (blink rapidly) and a beep will indicate that the cycle has not finished.
To resume the wash cycle, press
close the door. When the door closes, the cycle will start from where it was interrupted. This
operation should be performed only if necessary as it could cause irregular performance.
CHANGING THE CURRENT WASH CYCLE
To change the current program, simply open the door of the dishwasher and press
the new program. Close the door to run the new program automatically.
CANCELLING THE CURRENT WASH CYCLE
To cancel the current program:
1. Open the door then press and hold
the indicator lights of the fourth and fifth cycles turn on.
2. Close the door again.
The dishwasher will pump out and finish for about 1 minute. Then it will stop and the "Program
Run" light will go OFF. When you open the door, the indicator lights of the fourth and fifth
cycle will flash.
OPTIONS:
These are functions to tailor the dishwasher program for your particular needs, such as delayed
start, Half load, and more. (For descriptions of the basic cycles, see "Wash Cycles" on page 11.)
DELAY START
• Available for all programs except Soak.
The DELAY START function delays the beginning of the wash cycle up to 24 hours beginning
from the moment the delay programming is entered. This makes it possible to use the
dishwasher at a specific time of day.
Before programming a delay, open the door of the dishwasher and select the required washing
program. Select the delay by pressing the
the delay before the appliance starts is increased by 1 hour.
14
©2019 Hestan Commercial Corporation
(CONT.)
Select once (the indicators will then blink slowly) and then
Select
Delay Start
(the cycle selection button) for a few seconds until
button. Each time you press the button,
Select to select