Energy Saving And Environmental Respect; First Use - hestan KDW Mode D'emploi

OPERATION
REMOVING DISHES
At the end of the wash cycle, wait 20 minutes before removing the dishes in order to allow them
EN
to cool. To prevent any water droplets falling onto dishes from the upper racks, empty the lower
rack items first and then the upper items.

ENERGY SAVING AND ENVIRONMENTAL RESPECT

• Always try to run the dishwasher fully loaded.
• Do not pre-wash the dishes under running water.
• Use the most suitable washing program for each type of load.
• Do not pre-rinse.
• If available, connect the dishwasher to a hot water system with a temperature of up to 140° F
[60° C].
• When possible, skip the drying cycle by opening the door after washing. The air and the
residual heat will dry the dishes to perfection.

FIRST USE

Once the dishwasher has been correctly installed, prepare for use as follows:
1. Add the regenerating salt. (see "ADDING SALT" on page 18) When using the dishwasher
for the first time, in addition to the salt it is also necessary to add one liter of water to the
container.
2. Add the rinse-aid. (see "USING THE RINSE-AID AND DETERGENT DISPENSERS" on
page 19)
3. Adjust the water softening system. (see next page)
4. Add the detergent. (see "ADDING DETERGENT" on page 20)
REDUCING THE CONSUMPTION OF DETERGENT
The phosphates contained in dishwasher detergents are harmful to the environment. To avoid
using excessive amounts of detergent and to save on electricity:
• Separate the more delicate items from those that are more resistant to aggressive detergents
and high temperatures;
• Do not pour the detergent directly onto the dishes.
16
©2019 Hestan Commercial Corporation
(CONT.)
BEFORE STARTING TO USE THE APPLIANCE, MAKE SURE YOU
HAVE READ AND UNDERSTOOD ALL THE WARNINGS
CONTAINED IN THE "PRODUCT WARNINGS/SAFETY" SECTION.