Choosing Wearing Preference; Making A Call; Ending A Call; Answering A Call - Jabra BT 250v Mode D'emploi

Status indicators
What you see What you hear
Flashes every Quick series of 2 tones
second – low to high pitch (when
active mode starts)
Flashes every Quick series of 2 tones
3 seconds – high to low pitch (when
standby mode starts)
3 flashes every 3 beeps every 30 seconds
second
3 flashes every 3 beeps every 5 minutes
3 seconds
* Depending on phone type and usage.
IMPORTANT: Do not hold the button down for more than 3 to 5 seconds when
turning the headset on or else it may go into pairing mode, and the blue indicator light
will turn solid. If that happens, turn off the headset, wait 3 to 5 seconds, and repeat
process for turning the headset on.
7

Choosing wearing preference

Jabra BT250v is ready to wear on the right ear. If
you prefer the left, gently rotate the MiniGel 180°.
For optimal performance, wear Jabra BT250v and
your Bluetooth phone on the same side of your
body. In general, you will get better performance
when there are no obstructions (including parts of
your body) between the headset and the phone.
6
Status
Active Mode⁵
•
Call in progress
•
Up to 7 hours of talk-time*
Standby Mode⁶
•
Waiting for call
•
Up to 200 hours of
standby time*
Low Battery (in active mode)
•
3 – 5 minutes of talk time left
Low Battery (in standby mode)
•
3 – 5 minutes of talk time left
Fig. 4
8

Making a call

If Jabra BT250v is off, turn it on now (see Turning headset on/off section).
Using phone's keypad
1. Dial number on keypad.
2. Press phone's "send" key.
Using voice-activated dialing (after you've set up voice tags on your phone)
1. Press and release once. You'll hear 1 short beep while doing this.
2. You'll then hear the voice-activation tone; say the name of the person you wish to call.
NOTE: Record voice tag from headset for better reception.
9

Ending a call

•
Press and release once
OR
•
End call from phone's keypad
10

Answering a call

•
After you hear the ring tone, press and release
OR
•
Answer the call with your phone's keypad. You may then need to transfer the call to
the headset by pressing and releasing once (depending on your phone)
11

Call-waiting*

•
(Recommended) Use standard method from your phone's keypad which typically
involves pressing the "send" button
OR
•
Press and release once to answer the incoming call and toggle between calls
(some phones do not support this headset feature)
once
7