Valve Zone; Base Plates - Aventics AV03 Description Technique Et Mode D'emploi

6
1
Fig. 2: Example configuration: unit consisting of IO-Link interface and AV series valves
1 IO-Link interface with valve drivers
6 Pneumatic supply plate
7
1
7 Multipole board (not visible)
8 Right end plate
9 Pneumatic unit, AV series

10.2 Valve zone

The following figures show the components as illustrations and symbols. The symbol
representations are used in "10.4 Conversion of the valve zone" on page 63.
10.2.1

Base plates

The valves from the AV series are always mounted on base plates that are assembled into blocks so
that the supply pressure is applied to all valves.
The base plates are always 2x or 3x base plates for two or three single or double solenoid valves.
The first two base plates for minimal configuration of the IO-Link interface are always 3x base
plates.
AVENTICS | AV03/05 with IO-Link | R412018145–BAL–001–AC
9
59
Conversion of the Valve System
8