Güde ECO WHEELER 1600 E Traduction Du Mode D'emploi D'origine page 15

Symptom Possible cause
No system voltage
Defective On/Off
button
Defective engine
Engine not
starting
Grass is too high
Worn-out carbon
brushes
Obstruction by
Engine failing
foreign items
Grass is too low
Blunt knife
Unsatisfactory
cutting result;
Obstructed knife
engine running
area
heavy
Knife fitted
inappropriately
Obstructed knife
Cutting knife
not rotating Bolt on the knife is
loose
Abnormal Bolt on the knife is
sound, loose
clattering or
unusually Damaged knife
strong
vibrations
Removal
Check the outlet,
cable, conductor,
plug and have them
repaired by an
electrician if
necessary
Repair by an
electrician
Repair by an
electrician
Increase the cutting
height by pressing
the sliding handle
down and lift slightly
the front wheels
Replacement by an
electrician
Remove the foreign
items
Lower the cutting
height
Have the knife
sharpened or replace
it
Remove the
obstruction
Fit the knife properly
Remove the grass
Tighten the bolt on
the knife
Tighten the bolt on
the knife
Have the knife
replaced
15