Setting Filtering (Fil); Setting Display Backlighting (Lcd); Setting Standby Time (Aoff) - Seca 336 Mode D'emploi Et Garantie

Setting filtering (FIL)

Setting display backlighting (Lcd)

Setting standby time (AOff)

Filtering (FiL) allows you to reduce interference (e.g. as a result of patient
movement) when determining weight.
1. Select the item "FIL" from the menu.
2. Confirm your selection.
The current setting is displayed.
3. Select a filtering level.
– 0: low filtering
– 1: moderate filtering
– 2: high filtering
4. Confirm your selection.
You exit the menu automatically.
You can change the duration and brightness of display backlighting.
1. Select the item "Lcd" from the menu.
2. Confirm your selection.
3. Select a menu item:
– dUr: Duration
– brI: Brightness
4. Confirm your selection.
The current setting is displayed.
5. Select the desired setting:
Function
Duration
Brightness
6. Confirm your selection.
You exit the menu automatically.
7. If you also want to make settings for the second function, repeat the
process.
In battery mode, the scale remains on standby for 60 seconds (factory set-
ting). If there is no input during standby time, the scale switches off automati-
cally. Measured results will be discarded. You can adjust standby time:
Function
Factory setting
Increment
Minimum standby time
Maximum
standby time
Proceed as follows to adjust standby time:
1. Select the item "AOff" from the menu.
2. Confirm your selection.
The time currently set is displayed (in this case: 600 seconds).
3. Select the desired time:
►
To increase value: Press
►
To reduce value: Press
Setting
• Short (approx. 15 sec.)
• Long (approx. 45 sec.)
• PErM (permanently)
• 50 %
• 100 %
• Off
Setting
60 seconds
30 seconds
30 seconds
600 seconds (10 minutes)
arrow key
hold
arrow key
tare
English
Operation • 63